#Arduino mega 2560 uart pins serial

For floating point numbers, this parameter specifies the number of decimal places to use. Serial.print(78) gives '78' Serial.print(1.23456) gives '1.23' Serial.print('N') gives 'N' Serial.print('Hello world.') gives 'Hello world.' An optional second parameter specifies the base (format) to use permitted values are BIN (binary, or base 2), OCT (octal, or base 8), DEC (decimal, or base 10), HEX (hexadecimal, or base 16). Floats are similarly printed as ASCII digits, defaulting to two decimal places. Numbers are printed using an ASCII character for each digit.

#Arduino mega 2560 uart pins serial

Prints data to the serial port as human-readable ASCII text. Serial.begin(9600) // opens serial port, sets data rate to 9600 bps Speed: in bits per second (baud) - long config: sets data, parity, and stop bits. Serial.begin(speed) Serial.begin(speed, config)Īrduino Mega only: Serial1.begin(speed) Serial2.begin(speed) Serial3.begin(speed) Serial1.begin(speed, config) Serial2.begin(speed, config) Serial3.begin(speed, config) The default is 8 data bits, no parity, one stop bit. You can, however, specify other rates - for example, to communicate over pins 0 and 1 with a component that requires a particular baud rate.Īn optional second argument configures the data, parity, and stop bits. Sets the data rate in bits per second (baud) for serial data transmission. To use them to communicate with an external TTL serial device, connect the TX pin to your device's RX pin, the RX to your device's TX pin, and the ground of your Mega to your device's ground. To use these pins to communicate with your personal computer, you will need an additional USB-to-serial adaptor, as they are not connected to the Mega's USB-to-serial adaptor. The Arduino Mega has three additional serial ports: Serial1 on pins 19 (RX) and 18 (TX), Serial2 on pins 17 (RX) and 16 (TX), Serial3 on pins 15 (RX) and 14 (TX). Click the serial monitor button in the toolbar and select the same baud rate used in the call to begin(). You can use the Arduino environment's built-in serial monitor to communicate with an Arduino board. Thus, if you use these functions, you cannot also use pins 0 and 1 for digital input or output.

It communicates on digital pins 0 (RX) and 1 (TX) as well as with the computer via USB. All Arduino boards have at least one serial port (also known as a UART or USART): Serial. Serial is used for communication between the Arduino board and a computer or other devices. Don't connect these pins directly to an RS232 serial port they operate at +/- 12V and can damage your Arduino board. Serial communication on pins TX/RX uses TTL logic levels (5V or 3.3V depending on the board).